8
For DAG12
To activate the
Auto Scan
, press and hold the
pushbutton down for 2 seconds till you hear a long
beep followed by a short beep. To exit from it tap the
pushbutton again.
To change the
Scan Time
interval, press and hold the
pushbutton for 4 seconds till you hear two long beeps.
Then by tapping the pushbutton each time, the DAG12
responds with 1, 2, 3 or 4 beeps corresponding to 3, 8,
15 or 30 seconds respectively. Once set, leave the
DAG12 as it is and it will automatically return for
normal operation.
For DAG14
To activate
Auto Scan
, press down front panel push
buttons "3" and "4" simultaneously. The port LED
flashes during
Auto Scan
.
Auto Scan
is effective for
powered-on computers only. To exit the
Auto Scan
mode, just tap any one of the pushbuttons.
To change the
Scan Time
interval, press both front
panel buttons "1" and "2" simultaneously. The
DAG14 beeps 1, 2, 3 or 4 times for
Scan Time
of 3, 8,
15 or 30 seconds respectively.
Summary of Contents for AcroGear DAG12
Page 1: ......