REXROTH IndraControl L25 CML...3N Series, Project Planning Manual

Page: 49 / 72

Fig.8-3: Removing a terminal
Changing a terminal If you want to replace a terminal within the Rexroth Inline station, proceed as
described above to remove it. Do not latch on the adjacent connector of the
neighboring terminal to the left yet.
Fit the new terminal. Subsequently, refit all connectors.
8.2.4 Fuse Replacement
f segment terminals with fuse are used, the connected voltage and the state of
the fuse are monitored and indicated by diagnostic displays.
A missing fuse has to be installed; a defective fuse has to be re‐
placed.
When replacing the fuse, please observe the following instructions on the safety
of your health and the protection of your station!
1. Always use the screwdriver with care to prevent yourself and any other
person from being injured
2. Pry out the fuse at the metal contact. Do not pry the fuse out at the glass
body to prevent the latter from being broken.
3. Pry out the fuse carefully on one side and then remove it by hand. Take
care not to drop the fuse into your station.
Proceed as follows to replace the fuse. Also see the illustrations in fig. 8-4
"Fuse replacement" on page 48 :
● Swing up the fuse lever (A)
● Put a screwdriver behind a metal contact of the fuse (B)
● Carefully pry out the metal contact of the fuse (C)
● Remove the fuse by hand (D)
● Latch in the new fuse (E)
● Press the fuse lever down again until it clicks into place (F)
DOK-CONTRL-IC*L25*****-PR03-EN-P
Rexroth IndraControl L25 Bosch Rexroth AG 47/69
Installation and Maintenance