REXON SM2158R, Instruction Manual

Page: 8 / 32

8
TRANSPORTING THE SAW (FIG. 1)
To avoid damage, never carry the miter
saw by the switch handle, the cutting
arm or the miter handle. ALWAYS use
the designated carrying handle (24).
To lock the cutting head: When
transporting or storing the miter saw,
the cutting head should always be
locked in the down position.
1. Press the cutting head down to its
lowest position.
2. Push the hold-down latch (27) into
the locking hole.
CUTTING HEAD (FIG. 2)
Raising
To unlock the cutting head from the
collapsed position:
1. Push down the switch handle (1)
slightly.
2. Pull out the hold-down latch (2).
3. Raise the cutting head to the
uppermost position.
NOTE: This cutting head is spring
loaded.
Locking
1. Push the cutting head down to its
lowest position.
2. Push the hold-down latch (2) into
the locking hole to lock the cutting
head.
Assembly
WARNING! For your own safety,
never connect the plug to power
source outlet until all assembly
steps are completed and you have
read and understood the safety and
operational instructions.
UP
Specifications
Motor ..............400 W, S6: 20%, 10 min
220 V~, 60 Hz, Double Insulation
No load speed .......................5000 min
-1
Blade ...................................... Ø216 mm
Ø25.4 mm Bore, 40 T
Turntable ................................ Ø230 mm
Miter stops ......0° ,15°, 22.5°, 31.6°, 45°
left & right
Miter angle range ......................0° ~ 48°
left & right
Bevel stops ............................0°, 45° left
Bevel angle range ...............0° ~ 47° left
Net weight ..............................14.15 KGS
Cutting Capacity
Cross cut
(Maximum Height) .......... 64 × 279 mm
(Maximum Width)............. 51 x 305 mm
Miter cut at 45°................ 64 × 203 mm
left & right
Bevel cut at 45° left......... 38 × 279 mm
Compound cut at 45°....... 38 × 203 mm
NOTE: Move all parts to
the desired work site before
assembling them together.
Follow the assembly
instruction and carefully assemble the
tool with the help of a second person.
WARNING! To avoid injury and
damage to the saw, transport and
store the miter saw with the cutting
head locked in the down position.
Never use the hold-down latch to
hold the cutting head in a down
position for cutting operations.