REXON AP3300, Instruction Manual

Page: 9 / 20

6
ADJUSTING THE EXTENSION TABLE
(FIG. 5, 6)
1. Pull out the cutterhead lock lever (1) to
unlock the head. (Fig. 5)
2. Turn the depth adjustment handle (2) to
raise the head. (Fig. 5)
3. Place a straight edge over the extension
tables and the main table.
4. Press down the straight edge against
the table extensions to remove any play.
5. If adjustment is required, fold up the
extension table and loosen the lock nut
(3) and adjust the adjustment bolt (4)
until the tables are level. (Fig. 6)
ADJUSTING THE DEPTH SCALE (FIG. 7)
1. Try to plane a board.
2. Compare the measured thickness of
the board to the reading on the depth
scale (2).
3. If the reading on the depth scale is
incorrect, loosen the screws (1) and
adjust the pointer (3) until the proper
measurement is displayed.
4. Test the reading again by planing
another scrap wood. Double check it
and re-adjust if necessary.
SETTING THE KNIFE HEIGHT
(FIG. 8, 9, 10)
1. Remove the dust collector.
2. Remove the two screws (1) with a
screwdriver, and then remove the dust
cover (2). (Fig. 8)
2. Loosen the eight hex bolts (3) with
supplied wrench. (Fig. 9)
3. Press the lock latch (4) and carefully
turn the cutterhead until exposing two
adjustment bolts (5). (Fig. 10)
4. Place the knife setting gauges (6) on
the cutterhead with both guides resting
firmly against the knife. (Fig. 10)
WARNING! To avoid injury from an
accidental start-up, make sure the switch
is in the OFF position and the plug is not
connected to the power source.
5. Loosen or tighten two adjustment bolts
(5) with hex wrench until the knife
touches the knife setting gauge (6).
(Fig. 10)
6. Fasten the eight hex bolts (3) with the
supplied wrench. (Fig. 9)
7. Replace the dust cover (2) and secure it
with the two screws (1). (Fig. 8)
8. Replace the dust collector.
Operating the Tool
THE NO VOLT RELEASE (NVR) SWITCH
FOR THE THICKNESSER (FIG. 11)
Your thicknesser is equipped with a No Volt
Release (NVR) switch with emergency stop
cover. This device can provide to stop the
thicknesser immediately in urgent condition.
The main switch, No Volt Release (NVR)
switch (1), is on the front of thicknesser.
Press “I” to turn on the power; press “O” to
turn off the power. When the power breaks
off accidentally, press “I” to restart. The
emergency stop cover (2) will allow you
to stop the operation of this thicknesser in
ugent condition by hitting it by hand.
BASIC THICKNESSER OPERATIONS
(FIG. 12, 13)
WARNING! Never connect the plug to the
power source outlet until all instructions
and adjustments are completed and you
have read and understood the safety and
operational instructions. Remove the safety
key whenever the thicknesser is not in use.
Place it in a safe place and out of reach
of children.
WARNING!
● Allow the motor to come up to full
speed before starting cut.
● Always feed the work in the direction
that allows the thicknesser blades to
cut with the grain. Feeding against
the grain will cause the blades to lift
fibres from the work surface causing
a fuzzy appearance.