8
Installation and Operation
Due to excessive mishandling, this device could be damaged during
transportation. To avoid high cost of troubleshooting and repairs due to
repeated mounting and removal, we recommend that you assemble all
components first after delivery and test the device with the on-board
charger power supply. Make sure that the device is visibly undamaged
prior to installation. Contact our service center in case of any questions.
I.
Install the Device
1. Turn
off
the engine of the car.
2. Place the MicroSD card into the slot.
3. Secure the dashcam to the original rearview mirror of the car.
4. Plug the GPS module (sold separately) into the GPS port and secure the
module to a position close to A-pillar of the car. The antenna receiver side (the
side without 3M adhesive) faces the outside and the side with 3M adhesive
faces down. It should be properly secured.
5. Plug the charger into the car’s cigarette lighter and connect it to the dash
cam’s USB port with the included extended USB cable.
Note:
The optional rearview camera is mounted on the rear of the car. Pay
attention to its orientation during installation. Plug the rearview camera
connector into the corresponding port of the dashcam once the installation is
completed. Adjust the position of the lens to ensure that it aligns horizontal with
the ground. Start the engine to check the video functionality of the device.
Summary of Contents for M2
Page 1: ...M2 Users Manual ...
