4
REQUIREMENTS FOR PROPER INSTALLATION
This unit can be assembled by an adult in 2 hours. Follow the instructions in this manual step-by-step. Before installation, have
the following tools close at hand:
*Some models include funnel
2. BEFORE CONNECTING THE FILTER
2.1. LOCATION
Place the filter on a flat, solid surface at a minimum distance of 3.5 meters from the pool (in accordance with standard installa-
tion regulations of electrical appliances in swimming pools in force in each region or country) at the same level as the bottom
of the pool to prevent air from entering the cleaning circuit and to ensure that the filter remains primed. The filter should be
protected from the sun and rain, and kept in a sufficiently ventilated area during operation. Never cover it during operation.
Installation should be carried out using hoses of a maximum length of 4.5 meters that enable the filter unit to be placed on a
flat, solid surface at least 3.5 meters away from the pool. Should the hoses be too short, contact your service engineer.
It is important to check that the suction ports are not blocked.
During the installation process, if in doubt, contact the vendor of the unit.
2.2. ASSEMBLY
Once the unit is in place, proceed as follows: (See pages
10 to 14).
1. Attach filter to the mass filter according to model
(Ø300-Pag. 10-14).
Fix the pump to the base with the screws and washers
supplied.
2. Place the inner collector correctly on the bottom of the filter.
•
Cover the mouth of the collector situated on the inside of the filter with a plastic protector to make sure sand does not
enter (Fig.3).
•
Put the sand inside the filter: the height of the sand should not exceed 2/3 of the height of the tank (Fig.3).
•
Remove the remains of sand from the filter opening and take off the protective plastic.
3. Put the selector valve with its coupling in place and secure with the metal band or seal (Fig.4).
•
Firmly tighten the screw on the metal band that joins the valve to the filter (Fig.4).
4. Pressure gage assembly.
5. Connect the (PUMP) and (RETURN) terminals of the selector valve to the corresponding hoses, tightening them firmly with
the clamps. (Fig.6).
NOTE: Check that the hoses allow the filtration unit to be located and fixed on a flat, solid surface that is more than 3.5 metres
from the pool.
PROCESS
TOOLS
Tightening the hose
flanges
7 mm Stecker / Phillips
screwdriver
Tightening the pump’s
screws
13-mm wrench
Collector pipe protection Piece of plastic*
Summary of Contents for Mass Filter
