Charge the battery
First, be sure that the toggle switch on the top of the “tank” is
switched to the off position.
Locate the battery charger port which is on the right side of the
bike and flip up the small round black protective cap. Under this
cap you will see a round connector with three small contact posts.
Note that there is a small locating spline at the bottom of the
connector.
On the round end of the battery charger cord, you will see a plug
that has three small holes a notch which fits into the connector on
the bike.
1.
Plug the charger into a wall outlet. If the lights on the charger
do not light up. Check the power to the outlet. If necessary, try
a different outlet.
2.
Turn the bikes power switch OFF before charging. Plug the
charger into the charger port on your Revvi.
3.
The light on the charger should be red. You need to leave it on
charge until the light goes green. The green light indicates that
it is fully charged.
It is important to charge the battery fully before using it for the
first time.