Revv
Owner’s Manual
7.0
foot switch
The Foot switch that is used with the Generator is not like most foot switches. This
unit not only controls the amplifiers functions, it can also be used as a MIDI pro-
gram bank pedal. It has been designed with 2 modes, control (See 7.2) and Preset
(See 7.3) modes.
Note: The foot switch will always be updated should a change be made on the amplifier
front panel.
Note: To switch between modes, press and hold button one for 2 seconds (See 7.4). The
LEDs will all illuminate then switch to the setting in the other mode. All settings will be
retained when switching between modes.
7.1
7.2
Hook up
The Foot switch is connected to the rear
of the amplifier (See 3.9) with a shielded
Ethernet cable and very rigid connectors.
The amplifier and foot switch will work
with any Ethernet cable should you be
in a pinch, but the Revv cable is always
recommended for best performance.
It is recommended that the foot switch
be connected to the amp with the power
off, but should you plug it in once you
have been using the amplifier for a
while, it will power up and automatically
set itself to the amps current settings.
So if you have been jamming for a bit,
and have set the amp to your favorite
setting via the front panel but then
decide to plug the pedal in afterwards, it
will update itself automatically!
Upon power up, all LEDs will turn on for
a couple of seconds as it initializes. Once
complete, the foot pedal will set itself to
the amplifiers current configuration.
Control Mode
The foot pedal will always power up in
control mode. This mode works like
most other foot pedals; it simply controls
the functions of the amp. Here is how the
buttons respond in control mode:
Button One – This button has 3 func-
tions, it switches to channel one when
the amp is not in channel one, changes
channel one to either the clean amp
mode or crunch amp mode when the
