3
Frame Assembly Instructions
Package contents:
Remote Control
Retainer Bars & Hardware
Base Legs
Allen Wrench
Wireless Charging Pad (optional
accessory)
IMPORTANT UNPACKING
INSTRUCTIONS
To avoid damage to the power
base, always open the carton
while the power base is laying in
the FLAT position on the floor.
OPEN FLAT
STEP 1
STEP 2
STEP 3
STEP 8
STEP 5
STEP 4
STEP 6
Assemble the power base legs.
Screw them in a clockwise direction
into the threaded holes in the frame.
Remove the zip ties securing the
excess cord from the motors of the
power base.
Carefully flip the power base over with
2 people, to the topside-up position.
Plug the power cord into a grounded
electrical outlet.
NOTE: An electrical surge
protection unit is recommended
(not included)
WARNING: POWER CORDS
MUST NOT INTERFERE
WITH ANY POWER BASE
MECHANISMS.
ATTENTION!
Improper handling
DO NOT
lean the power
base against the
installed legs to
flip it over.
Use the Retainer Bolts and Retainer
Bar Plates to fasten the Mattress
Retainer Bracket to the power base.
NOTE: Use only a manual
screwdriver to install the retainer
bolts. DO NOT use a power
screwdriver to tighten the bolts.
STEP 7
Your power base has an emergency
lowering feature in the event that
your power base is in the raised
position and has lost power due to
a power outage. Your base includes
a built in battery supply that is
intended only for use with this
feature.
Emergency Power Down
Feature
NOTE: DO NOT raise the base
when powered with only backup
batteries. The batteries are only
intended to lower the base in
case of emergency.
WARNING: Remove the yellow
packaging bands from under the
frame before attempting to operate
the bed.
Remove the plastic packaging from
the power base. If there is a yellow
packaging band attached to the frame,
remove this as well.
NOTE: Be sure to use a
protective layer under the power
base to prevent damage to your
hard floors.
If you are installing a headboard,
proceed to follow the Headboard
Bracket Assembly Guide on our
website. If not, place your mattress
on top of the power base. Power
base assembly is now complete.
Manufactured by Reverie
®
For Warranty and Service:
1-800-973-8374
Please have your receipt ready and
available.
Thank you and enjoy your power
base.
www.reverie.com
Register Online. For easy
registration of your warranty visit
https://reverie.com/register-your-
warranty
Please prepare a digital copy of your
proof of purchase (invoice or sales
receipt) when registering online.
You may be required to provide the
Serial Number for registration, you
can find it on the Law Tags attached
to the base.
Carefully lift the power base unit
out of the shipping carton, keeping
the unit top side down. For safety
reasons, this should be performed
by 2 people. Be sure to lift the base
by the steel frame, securing the
head and foot sections of the base
so they do not move. Remove all
accessory components from the
undercarriage of the base.