3.
INSTALLATION
3.1.
GENERAL PRINCIPLES
The following figures show minimum distances between the air curtain
and the building partition
:
a)
wall mounting
-
unscrew the fixing screws to remove the mounting plate from the back
of the main body
-
install mounting plate on the wall
4.
INSTALLATION INSTRUCTIONS
4.1.
CONNECTION OF THE DEIVCE TO THE ELECTRICAL SYSTEM
-
all works concerning electrical installation should be made by the qualified
personnel (who possess required authorizations to install electrical equipment)
- plug should be put in an appropriate socket and if required, connect the door
switch according to wiring diagram (see point 7)
-
the electrical installation of the building shall have a residual current device
-
check the electrical installation before the first start
5.
PRECAUTIONS AND WARNINGS
During operation of the device, the following must be respected:
-
all works concerning electrical installation (disassembly, repair etc.) should
be made by the
qualified personnel, who possess the qualifications
due to the domestic and local norms, regarding electrical installations
-
do not limit or cover the inlet and outlet of the device
-
do not install, service the device with wet hands or barefoot
-
the device should be kept out of reach of children and animals
-
after the turn off, the elements of device may be warm
-
after operating time of the device, please utilize it concerning the local norms
and regulations
-
install the main body. Set the main body onto the upper end of the mounting
plate and clamp it as shown
The width of the curtain should be greater or equal to the width of the door
frame. When the entrance is wider than the unit, it is recommended to install two
or more units in parallel. In this case, provide 10-40 mm gaps between the units.
3.2.
ASSEBLY “STEP BY STEP”
The curtain can be assembled on wall or ceiling. If any components
are not included in the kit, you should buy them yourself and make sure
they are suitable for this type of installation.
