English
English
INSTrUCTIoNS For SaFe FlYINg
GENERAL FLyING TIPS:
• Always place the Quadrocopter on a level
surface. An inclined surface can, under
certain circumstances, have a negative
impact on the starting behaviour of the
Quadrocopter.
• Always operate the controls slowly and
with a gentle touch.
• Always maintain visual contact with the
Quadrocopter and do not look at the
remote control!
• Move the thrust control down again
somewhat as soon as the Quadrocopter
lifts off from the ground. Maintain flying
altitude by adjusting the thrust controller.
• If the Quadrocopter lowers, move the thrust
control slightly upward again.
• If the Quadrocopter climbs, move the thrust
controller down slightly.
• To fly along a curve, tapping the
directional controller very slightly in the
respective direction often suffices. There
is a general tendency during preliminary
attempts at flight to operate the
Quadrocopter's controls too aggressively.
Always operate the controls slowly and
carefully. Never fast and fitfully.
• Beginners should first master trimming
before attempting to master the thrust
controller. The Quadrocopter does not
necessarily have to fly straight at the
beginning - initially, it is more important
to maintain a constant height of
approximately one metre above the
ground by repeatedly tapping the thrust
control. Only then should the pilot
practice steering the Quadrocopter left
and right.
7 FlIghT CoNTrol (MoDe 2)
Note:
Only minimal corrections of the controls are necessary for a smooth flying
behaviour of the Quadrocopter! The direction information applies if the Quadrocopter is
viewed from behind. If the Quadrocopter is flying towards the pilot, it must be moved
in the opposite direction.
7A
Take off or increase altitude by carefully moving the control for thrust and yaw forward.
7B
Land or decrease altitude by moving the control for thrust and yaw backward.
7C
Fly forward by moving the controller for pitching and rolling carefully forward.
7D
Fly backward by moving the controller for pitching and rolling carefully backward.
7E
Fly to the left by moving the controller for pitching and rolling carefully to the left.
7F
Fly to the right by moving the controller for pitching and rolling carefully to the right.
7G
Turn the quadrocopter around to the left by moving the controller for thrust and
yaw to the left.
7H
Turn the quadrocopter around to the right by moving the controller for thrust and
yaw to the right.
Fly loops - advanced users only!
When you have sufficiently mastered your
Quadrocopter, you can try your hand at the stunt flying function. To do so, briefly press
the flip button on the remote control
(7I)
. Now the next control input forwards/
backwards or sideways will turn into a loop
(7J)
. Make sure that you have sufficient
room in each direction (at least 10 metres). Also observe the safety height – fly at a
height of at least 5m, as your Quadrocopter loses height when rolling over and has to
be caught and corrected afterwards!
Note:
Looping is more successful when the battery capacity is near full.
The quadrocopter has 2 flying modes with different levels of difficulty. The position
sensors of the copter can also be switched off - the quadrocopter then flies like a
single rotor helicopter
(Warning! Only for experienced users!)
.
Control adjustment:
By pressing the control for pitching and rolling
(2G)
, the sensitivity of the control can
be adjusted in two steps (Normal and Expert). In normal mode, the F-mode LED is off,
in Expert mode it is lit. When the remote control is switched, a low tone sounds for the
easier level and a higher tone for the more difficult level.
Warning!
Only switch to a higher level when you have mastered the lower one!
8 FlIghT MoDeS (F-MoDe)
BATTERy STATuS:
The LEDs on the Ominus will flash slowly when the battery voltage is low. The
Ominus should land as soon as possible to avoid damaging the battery. Always
unplug the battery after flight.
Helicopter mode (F-mode):
First set the sensitivity of the control as desired (see above). Now press the F-mode
button on the remote control, the F-mode LED flashes. The position sensors of the
quadrocopter are now switched off, the tilting position will no longer be corrected
automatically. This makes controlling the model more difficult, but enables more
complex maneuvers to be carried out - only for experienced users!
Warning!
Only switch the position sensors off once you have mastered flying with the
sensors activated!
18
19
Summary of Contents for RAYVORE
Page 28: ...54 55 Notes Notes ...
