FRONT COCKPIT ASSEMBLY
1
DECAL PLACEMENT
18
Kit 5983 - Page 2
Kit 5983 - Page 15
39
HYDRAULIC
HAND PUMP
CHROMATE GREEN
32
COCKPIT FLOOR
CHROMATE GREEN
1
RIGHT
FUSELAGE
CHROMATE GREEN
(INTERIOR ONLY)
40
FORWARD BOMB
BAY BULKHEAD
CHROMATE GREEN
37
COCKPIT BULKHEAD
CHROMATE GREEN
36
PILOT'S SEAT
CHROMATE GREEN
31
CONTROL COLUMN
CHROMATE GREEN
FLAT BLACK
BEND UP 90 DEGREES
BEND UP 180 DEGREES
*
*
42
OXYGEN HOSE
FLAT BLACK
41
AFT BOMB BAY
BULKHEAD
CHROMATE GREEN
WHITE WITH RED TIP
33
RIGHT SIDE
INSTRUMENTS
FLAT BLACK
(WITH ALUMINUM SWITCH-
ES AND WHITE LETTERING)
8
SLIP
BUCKLE
18
SLIP
BUCKLE
9
LEATHER
BACKING
12
LATCH
15
LAP BELT
ANCHOR
11
HARNESS
ANCHORS
15
LAP BELT
ANCHOR
15
LAP BELT
ANCHOR
8
SLIP
BUCKLE
7
BUCKLE
CATCH
14
LEFT
HARNESS
CATCH
13
RIGHT
HARNESS
CATCH
PHOTO ETCHED METAL PARTS
MAKE HARNESSES AND LAP BELTS
FROM STRIPS OF PAPER
FOR ADVANCED MODELERS, OPTIONAL PHOTO ETECHED METAL PARTS, IF NOT USING PILOT SHOWN IN STEP 3.
This kit contains photo etched parts for added realism. use a sharp knife to remove the parts from their tree and cut against a hard surface like a piece of glass. Stick
a piece of tape to the back of the photo etch tree so the parts don't fly off and get lost. Carefully sand the photo etch pieces to remove any remnants of their mounting
points. Some photo-etched parts will need to be sanded to fit properly. To attach the photo etched pieces to your model, use a toothpick or piece of wire to apply a
small amount of CA superglue, two-part epoxy, or clear enamel paint to your model. Then the photo etched pieces can be put into place using tweezers or a toothpick
dipped in candle wax.
