Reveal ZERO ZONE, Installation & Operation Manual, Page: 14 / 25

12 • Installation & Operation
INSTALLATION & OPERATION
Alternate Bumper Splice & Glass Front Splice
Some cases have an alternate bumper, which may include an optional glass front. When joining these cases together, special splice pieces will
be provided. First, hook the bumper splice over the bumper and fasten it under the bumper so it covers the seam. Next, install the cap splice or
the glass front splice. The cap splice hooks over the back of the handrail and fastens inside the case and into the bumper splice ( See Figure
15 ). The glass front splice slides down over the glass and fastens inside the case ( See Figure 16 ).
Drain
The drain can be accessed through the drain access port in the center of the floor pan in the bottom of the case ( See Figure 17 ). The 1 1/2"
pVC drain outlet is located at the center front of the case behind the kickplate.
The drain line exits the case in the center. The lateral runs of drain pipe should be installed through the bases ( See Figure 18 ). There is no
room in front of the base for the drain pipe because the kickplate installs directly to the front of the bases.
Install the drain tee to the outlet pipe and a drain trap to the tee. plug the open end of the tee using the clean-out plug supplied with the drain
trap kit. The drain line must be pitched away from the case. The tee, drain trap, and plug are supplied with the case. The drain trap must be
level. The drain trap should be primed with water after installation. The drain line must be pitched away from the case enough to ensure proper
drainage. Consult your local codes for minimum requirements.
The forward drain section, tee, and “R” trap are shipped loose for field installation.
FIGURE 15: Splices for Alternate Bumper with Cap
Alternate Bumper Splice
(fastens in front)
Cap Splice
(fastens in front
and inside)
FIGURE 16: Splices for Alternate Bumper with Glass
Glass Front Splice
(fastens inside)
FIGURE 17: Drain Access Port FIGURE 18: Drain Installation