6
INSTALLATION: TOE-KICK & GRILLE REMOVAL / DISCONNECTING CASE FROM SKID
1. Remove Front Toe-Kick From Case
To prevent damage to case, remove front
toe-kick from case before removing from Skid.
Toe-kick is held in place by magnets only. No
screw removal is required.
Place front toe-kick in secure location while
removing case from Skid.
2. Remove Air Intake Grille From Case
To prevent damage to case, lift air intake grille
UP and OFF
case.
Air intake grille is held in place by magnets.
Toe-Kick
No screw removal is required.
Place air intake grille in secure location
while removing case from Skid.
3. Disconnect Case From Skid
Use Phillips driver to remove screws
from shipping brackets. Remove and
discard shipping brackets from Skid.
Place J-bar/pry bar under base frame.
Raise case up from Skid to take
weight off casters.
With case raised, lower casters all the
way down against Skid (see next step
for detailed instructions on lowering or
raising casters).
Remove rubber shipping blocks.
Skid
Rubber
Shipping Block
Shipping
Bracket
Air Intake Grille