DIRECTIONS FOR USE
AROMATHERAPY (OPTION)
Reval give all areas of patient well-being and safety careful consideration. Its unique “Aromatherapy” system combines the
benefits of hydro-massage with the relaxing aromatic effects, of infused aroma essence, providing the ultimate bathing and
rehabilitation experience. The “Aromatherapy” system is compressed heated fresh air technology, which infuses aroma
therapy oils at temperature into the hydrotherapy air jet which explodes into the bath water delivering controlled therapy
with sensual and relaxing aromas assuring a totally unique and wonderful experience. Reval's new “Aromatherapy” system
has an ultra-safe auto-clean function which self-dries and cleans the internal air ducting pipe work after use automatically.
The auto-clean function significantly reduces the risk and development of micro -biological organisms that can develop in
humid and wet environments. Reval's unique air ducting system can be dismantled without the need for tools and can be
termically cleaned during routine servicing in a matter of minutes.
.
TO OPERATE:
1.
Simply remove the chrome cap, take the wooden spatula, soak in aromatherapy oil and replace it in to the essence
well. Replace the chrome cap) finger tight). Do not over tighten!
2.
Switch the Aromatherapy system on via the circular control panel. Once up to temperature the heated air infuses with
the aroma oil and releases its fragrance into the water via the diffuser jets positioned in the bottom of the bath tub.
The aroma is carried inside the bubbles and explodes on contact with the water releasing the sensual aromatic
fragrances in to the air.
3.
For extended use switch off and re-soak the spatula as described in points 1&2.
4.
The hydro Aromatherapy has an alternating intensity function. To activate this potion press the button on the control
panel. The intensity will increase and decrease automatically providing needed therapy without sensitivity and
discomfort for those with sensitive joints and skin conditions.
5.
The intensity can also be set at a fixed pressure for those who enjoy the continuous sensation and work-out. To fix the
intensity level simply press the + or – button on the control panel until the desired intensity has been found.
6.
To switch off press the middle button on the control panel marked 1/0.
7.
The Aromatherapy system has a self-cleaning function called “Auto Clean” Once the system has been switched off the
status LED on the On/Off button changes from ON to Intermittent flashing. This indicates that the system has gone
into stand-by mode and will
Automatically switch on again and run for 5 minutes self-drying any build-up of humidity in the internal hydro
plumbing system. After five minutes the system will shut down.
12/20
