Reva G-Wiz, Owner'S Manual

Page: 22 / 100

1.7 Door Locks - Central Door Locking System
Instrument Cluster and Controls
1. Operation with Remote:
The car can be locked or unlocked by
pressing Button 1 on the remote unit.
A locking action is accompanied by a
single 'Flash’ of Turn indicator lights,
Unlocking action is accompanied by 3
flashes of Turn indicator lights.
It is advisable to operate the remote
while the car is within visual range,
as the car’s alarm system is of the
visual type (turn indicators flash) and
NOT the audible (siren) type.
NOTE
2. Automatic Door Locking/
Unlocking (*if programmed)
1.
Doors get locked automatically after
20 sec. when you turn ON the Key
Switch (provided the doors are
closed and the car is in the disarmed
condition).
2. Doors get locked automatically after
30 sec., once it is unlocked by the
remote.
3. Doors get unlocked automatically
when you turn OFF the Key Switch.
‘BUTTON 1’
LOCK / UNLOCK
‘BUTTON 2’
22
1.7 Door Locks
Instrument Cluster and Controls
DOOR LOCKS -
I. TO LOCK/ UNLOCK
MANUALLY:
To lock or unlock your car manually,
turn the key in the clockwise or anti-
clockwise direction respectively as
shown in the figure.
To lock from inside, push door lock
lever towards front of car and push it
back to unlock as indicated in the figure.
Always ensure to lock both the
doors while driving.
Locking the doors will guard the
occupants from being thrown out in
case of accidental opening of a door.
CAUTION
II. TO OPEN THE DOOR:
UNLOCK
(anti-clockwise)
LOCK
(clockwise)
UNLOCK
LOCK
Your car has been equipped with
factory fitted central door locking
(CDL) system. Hence the keys must
be used to lock/unlock the doors
only when the CDL system is not
functional.
NOTE
III.
TO LOCK/ UNLOCK
AUTOMATICALLY -
USING CDL
Your Car is fitted with a Central Door
Locking (CDL) system, which has the
following features:
1. Remote lock/ unlock of car.
2. Immobiliser.
3. Remote car heating/cooling*.
(continued)
21
3. Car ‘Armed’ Position
After 45 seconds of locking operation
car enters in to ‘armed’ condition and
CDL system LED indicator flashes
continuously. Any attempt to do the
following events causes alarm:
i) Cutting of system wire.
ii)Disturbing the UN-switched supply
loads.
iii)Attempt to turn ON key switch.
iv)Attempt to open the doors.
V
) Panic alarm – by pressing Button2
on the remote.
Under alarm conditions, flashes will
come for 30 seconds, and heater comes
ON with blower running at 4th speed.
If the event is still happening even after
30 seconds, then flashes continue for
further 30 seconds.
Downloaded from www.Manualslib.com manuals search engine