Transmitter start-up:
(4)
(5)
(6)
(7)
(8)
5. Open the battery compartment
by unscrewing the screw
. Remove the battery isolation stripe. Place the
included battery (12 volt alkaline type: 23A) according to
the polarity instructions.
6. Press the doorbell button
. The pilot light
lights up. On
the receiver, the signal tone sounds and the signal light
flashes.
You can make your melody selection with the switch
. Press
the switch briefly and the next melody will sound.
After the end of the melody, you can press the switch
again
to hear the next selection.
After a battery change, the desired melody must be selected
again with the switch
.
(9)
(9)
The selected melody remains stored until you change the
batteries.
(9)
Melody selection
Following melodies are selectable
01. Westminster
02. DING DONG (2 x)
03. Telephone ring
05. Banjo on my knee
06. Twinkle
07. It is a small world
04. Circus Theme
08. Barking dog
Changing the coding:
The four code plugs on the transmitter and receiver (10) should
only be changed if the system activates itself without its own
transmission signal. Depending on your selection, disconnect
the plugs and place them only on the upper contact.
Example:
ENGLISH
12
IMPORTANT: Plugging and pulling of the
plugs is free selectable. The change must
occur in the same plug position on both
devices (receiver and transmitter).