REV Midwest Automotive Design American Coach Patriot 2022, Owner'S Manual

Page: 95 / 178

A M E R I C A N C O A C H P A T R I O T O W N E R ’ S M A N U A L
A M E R I C A N C O A C H // P A T R I O T S E C T I O N 9 // 9 3
require an “Enable” icon button to be held for 3 seconds to confirm
AGS activation�
Touch the “Inverter” icon to power the inverter on or off� A blue
“Inverter” icon indicates the unit is on� A grey “Inverter” icon indicates
the unit is off� Keep in mind that the inverter will quickly deplete the
house battery bank if the coach is not connected to shore power or
another power source such as the chassis’ 3�0 diesel engine alternator
or the optional Onan LP generator� See the INVERTER section below
for further instructions on the operation of the inverter�
Your coach may have an “Energy Management” section on the
“Electrical” page. The Energy Management System (EMS) will activate
when the AC Power Management option is selected� EMS does not
operate when connected to shore power, or whenever the generator is
running�
Once activated, the EMS loads are shed according to the
following priority order:
1. Dometic AirCon - This is present if no ProAir options are
enabled, or if ProAir Clutch is enabled without ProAir Variable;
2. Convection Stove - EMS will try to turn on this load (OFF ch�
10) as soon as the system starts if there is power. This will
turn ON ch� 10 if the load is SHEDDING or OFF� There is no
on-screen control for the induction cooktop; and,
3. Water Heater - This will turn ON ch� 15 if the load is SHED-
DING or OFF� It will also turn the Water Heater icon button
color to yellow if it is shedding with ch 15�
ON�
Tap the icon button to Enable or Disable AGS� A warning message
will require action to Enable� Two “Trigger Options” are available to
automatically start the generator using specified voltage settings (Low
Volts) or when A/C or Heat starts (HVAC). Select one or both
triggers� If no triggers are selected, AGS will not run� Disable HVAC
Load while you are connected to shore power to prevent the
generator from starting�
Set the trigger options as follows:
Start at Volts - The generator will start when the voltage drops to
this set point depending on the “Time at Start Volts” setting below�
(Available range is 10.5v – 12.5v);
Time at Start Volts - The generator will start when the voltage drops
to the Start at Voltage for this specific amount of time. (Available range
is 5 seconds – 1 minute);
Stop at Volts - The generator will shut off when the voltage reaches
this set point depending on “Time at Stop Volts” setting below�
(Available range is 13.2v – 14.5v); and,
Time at Stop Volts - The amount of time required for the voltage to
remain at “Stop at Volts” level before the generator shuts off�
(Available range is 5min – 120min).