FIRST Global Building Guide Created by REV Robotics 2019, Licensed Under CC BY-SA
21
STEP 5
Take the slider plate assembly from Step 1 and slide the
hex cap bolts into the extrusion channel on the side
adjacent to the double-sided slider.
Once the slider is fully inserted into the channel, tighten
the bolts just until snug.
OVERTIGHTENING MAY CAUSE
SLIDER DEFORMATION AND BINDING.
The above steps 1-5 will result in the basic building assembly for a
linear motion elevator using the REV Robotics 15mm Linear Motion
Kit V2 and Extrusion (Figure 37). Repeat the steps 1-8 above for as
many stages as needed, a minimum of two assemblies are needed.
Figure 37: Basic Assembly (Steps 1-5)
Take two of the basic assemblies created in Steps 1-5
and slide them together.
