REV 93267, Operation And Maintenance Manual

Page: 9 / 68

9
GB
SETTInG THE FLOODLIGHT DIRECTIOn
• Loosen the screws on the sides underneath the housing and adjust the
floodlight direction – ensure that the handle is not illuminated – and then
retighten all screws.
The floodlight is now ready for use and can be operated under the intended
conditions – it is essential that the requirements specified under “General
Safety Instructions” in regards to the installation location are followed.
REPLACInG THE ILLUMInAnT
You can find the technical data for the illuminant under “Technical Date” or on
the type plate attached to the floodlight housing.
• Before opening the halogen floodlight, disconnect the power cable and
allow the floodlight to cool down sufficiently!
• Loosen the screw for the lens on top of the floodlight and swing the lens
forward.
• Remove the illuminant from the packaging.
• Avoid touching it with bare hands since this causes grease stains which
lead to overheating. Use a clean, dry, lint-free cloth.
• Plug the illuminant connection into the emitter coupling. Pay attention to
the fact that the holding clip does not get bent.
• Then close the lens and retighten the screw.
CLEAnInG
• Before cleaning the halogen floodlight, disconnect the power cable and
allow the floodlight to cool down sufficiently.
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent
if required. Do not use cleaners that contain abrasives or solvents.
MAInTEnAnCE
• Check the plug, power cable, and housing of the halogen floodlight for
damage before each use. If the lens is damaged it must be replaced
immediately.
• Clean any dirt from the housing or the lens immediately, since it could
cause overheating.
ANL_93267_32W_ESL_Stativ.indd 9 20.07.2012 15:39:51