REV Robotics MINI BOT, Assembly Manual

Page: 8 / 37

Building with the bolt head inside the extrusion and the nut sticking out is called building “stud up”
and is recommended when building with the REV Robotics Extrusion System.
Pay attention to the direction that bolts go into the brackets, only the bolt head will fit in the extrusion,
the lock nut will not fit.
4. Stud-up Building
When using Nyloc Nuts, make sure the beveled “Nyloc” side is facing out.
5. Nut Direction
Tip #4: “STUD UP” BUILDING
1) When threading a screw
and nyloc nut onto extrusion
2) Always thread the
screw head in
3) DO NOT try to thread the
nyloc nut in. It will not fit.
nut
screw head
nut screw head
nut
screw head
flip
beveled side flat side
Tip #5: NUT DIRECTION
1) Each side of the nut is different 2) Always make sure the beveled side is facing out
(nyloc side)
4
5