Controlling the Device
45
7.7.6 Software Update
The software can be updated using Section (
E7
).
NOTICE
A suitable USB data medium must
be inserted in the USB interface (
K
). The main directory may only contain the software to be
installed. The machine then automatically detects the new software.
Press the
symbol (
E7
) to perform an update.
Wait until the transfer and installation have been completed. The knob (
B4
) flashes until the
control element has been restarted. This can take a few seconds.
NOTICE
Error message "E80" is shown if no USB data medium has been connected or if an
external PC has been connected to the USB interface (
K
).
NOTICE
The USB storage device must be formatted in the FAT32 file system. USB 3.0 storage
devices are not supported.
7.7.7 Service Environment
Section (
E8
) provides access to the service environment. The service environment is only
accessible to service technicians from Retsch GmbH.
NOTICE
If the service environment has been activated by pressing Section (
E8
), the USB
interface (
K
)
is activated and “On” displayed beneath the
symbol, however no other
function is executed.
Deactivate the service environment by pressing Section (
E8
), or exi
t the “Settings” menu
using the
button (
B1.5
).
NOTICE
All other functions remain deactivated while the service environment is activated.
Summary of Contents for GM 200
