Operating the machine
24
Fig. 14:
The display (
F1
) shows 00.0. The current gap width and the display therefore
match.
The wear of the breaking jaws is not recorded by the gap width measurement. For
this reason the alignment of the gap width should be performed regularly in order
to guarantee matching between the information in the display and actual gap width.
The greater the load on the BB 50 and the harder and more abrasive the grinding
material, the more frequently a zero point alignment to compensate for wear is
required.
The reading in the display will otherwise not correspond to the actual gap width.
Pos : 9. 17 /0020 Übersc hrift en/1.1 Ü bersc hriften/ 1. 1 Ü berschrif ten BDA/11 Spalt weit e eins tell en @ 5\ mod_1345445670122_9. doc x @ 34150 @ 2 @ 1
5.7 Setting the gap width
Pos : 9. 18 /0005 RET SCH/ 0005 R ETSCH Bedienungsanlei tungen Kapit elsamml ung en/BB50/ 0007 Bedi enung/ 0010 BB50 M odul Spalt weiteneins tell ung @ 5\ mod_1346050883310_9.doc x @ 34530 @ @ 1
NOTICE
Before starting the machine, do not put any grinding material in the grinding
chamber or fill hopper. This can lead to a blockage and cause damage to
mechanical components.
•
You can
reduce
the gap width (
sw
) with a twist of the hand wheel (
D
)
in a clockwise direction
.
•
You can
increase
the gap width (
sw
) with a twist of the hand wheel (
D
)
in an anti-clockwise direction
Fig. 15: Gap width
sw
D
F3
