Preparing to Install Your Unit (Continued)
Assemble the Model One unit's Infinimount bracket and shaft system
using the supplied screws and shaft nuts.
Find the Infinimount shafts & brackets (2 of each enclosed)
Due to the flexible installation variations this system offers, in order
to match the Infinimount shaft & bracket system to the proper shaft width
of your vehicle, simply measure the distance between your existing shaft
holes center to center. Then mount the shaft system to the bracket using
suppled shaft nuts and shaft mounting guide, and finger tighten to prepare
for the final installation (see figure A below). Once you are sure of proper width,
then tighten prior to final installation. Be sure to plug the shafts into the side of
the main unit to activate the shaft-control functions (see figure B below).
X 2
Mount Shaft
to Bracket
Plug Shaft into
Side of Main Unit
A.
B.
11.
Rectangular shaft guide
w/ washers & nuts
Note: you can move our brackets forward
, backward, and in any direction to
accommodate your fit needs!
You can even cut, trim or bend the
bracket for your particular needs. Also if
you have a challenging install, you can
even create your own brackets!
