Step #5
Connect the Speakers
Step #6
Mount the Speakers
Step #7
Complete the Installation
Kick P
anel
Kick P
anel
Kick P
anel
Feed the speaker wires through the
speaker opening and connect to the
speaker terminals.
Connect the negative wire to the negative (-)
speaker terminal and positive to the positive
(+) speaker terminal.
Fit the speaker into the cutout and
secure it using the supplied screws.
If needed, place a speed clip over
each drilled hole before mounting
the speaker. (Some models may
require placing the grill base before
placing the speaker.)
Tighten all screws until the speaker is snug
and in place to prevent rattling. Be careful
not to overtighten the screws. Complete the
installation by placing the grill (if included)
over the installed speaker.
POSITIVE TERMINAL (LARGE)
NEGATIVE TERMINAL (SMALL)
NEGATIVE
POSITIVE
TIP:
How to Remove Speaker Grills
To remove speaker grills either pull up on the grill’s ring (Type A) or push down on the grill’s ring (Type B).
Type B: Push down to remove
Type A: Pull up to remove
