3
FRONT PANEL CONTROLS
POWER REQUIREMENTS
retroaktiv hlfo
HLFO Users Manual
LFO
RATE CV
CLK
RATE
RATE
S&H
CLOCK IN
S&H IN
S&H OUT
NOISE
OUT
NOISE
SRC
TRI
S&H
SQR
VCA
AMP
AMP
OUT
FSR
FSR
S&H
Figure 2 - HLFO Block Diagram
POWER REQUIREMENTS
HLFO is powered by
+/- 12VDC
and uses a 10 pin (2x5) IDC power cable. The
+12V
rail con-
sumes
24mA
of current. The
-12V
rail consumes
8mA
of current.
REAR PANEL CONNECTIONS
The HLFO module PCB contains additional inputs and outputs, allowing for bussing signals
between modules from the rear panel. This can be useful for normalizing modules in a rack, or
creating auxilliary inputs and outputs. J10 connections are as follows:
Pin 1 - Force sensor output (0 to 5V)
Pin 2 - CLK Out - (10V to -10V)
Pin 3 - Sample & hold output (-5V to +5V)
Pin 4 - LFO Output (Post VCA)
Pin 5 - External S&H source input (-10V to +10V) [Use jumper J11 to activate]
Pin 6 - Noise output
