3. Close the battery and tighten the two screws clockwise.
4. Tighten the screws clockwise to close the battery cover firmly.
Radio Battery Meter
Battery full bars indicates battery high . When battery meter shows 1 bar, device is on low battery mode and will
indicate low battery alert in the forms of alert tone and blinking bar display.
Note:
- Remove the battery from radio for storage purposes. Batteries may corrode over time and cause permanent damage
to your devices.
- Do not mix and use old/new/alkaline/NiMH batteries.
- Charge the supplied NiMH batteries once every 3 months when not in use.
Using the Micro-USB Charger
The micro-USB charger is a handy port that allows you to conveniently charge your NiMH battery. Use certified
adaptor(5V, ≥1A). Do not attempt to charge alkaline batteries.
1. Make sure your radio is turned OFF.
2. Plug the micro-USB cable into the micro-USB charging port on your radio. Connect the other end of the micro-USB
charger to wall power outlet.
3. The battery meter on LCD will move to indicate the battery is charging
Turning your Radio On and Off
1. Press and hold on the button to turn your radio ON/OFF.
2. The display screen then shows the current channel, code and all features that are enabled.
Insert 3 AA NiMH
batteries.
Close the battery
cover.
03
Setting the Volume
1. Press to increase the volume. Press to decrease the volume.
2. When the volume reached level 0 the mute icon appears permanently on screen.
RECEIVING AND TRANSMITTING
To communicate, all radios in your group must be set to the same channel and sub code.
1. To talk, press and hold the PTT button. When transmitting, the icon is shown. Release the PTT button when you
are finished talking. Do not use the radios closer than five feet apart.
2. When receiving, the icon is shown.
Monitor Button
1. Press and hold button for 3 seconds to enter monitor mode and listen for weak signals on the current channel.
2. You can also press button to check for activity on the current channel before you talk.
3. Release the button to exit monitor mode.
PTT Time out Timer
When you press PTT buttons for more than 60 seconds, radio will stop transmitting. This is to prevent accidental
transmission.
Mode Button
User can use this function to switch between two-way and weather mode by press and hold for 3 seconds.
FEATURES
Setting the Channel
1. Press the button until the channel number starts to flash.
2. Press or button to change the channel number. Press the PTT button to exit menu.
04
Summary of Contents for RT49P
Page 1: ...RT49P Two Way Radio ...
