Attention
Local Government Regulations
When the radios are used as a consequence of employment, the Local Government Regulations requires
users to be fully aware of and able to control their exposure to meet occupational requirements. Exposure
awareness can be facilitated by the use of a product label directing users to specific user awareness
information. Your Retekess radio has a RF Exposure Product Label. Also, your user manual, or separate safety
booklet includes information and operating instructions required to control your RF exposure and to satisfy
compliance requirements.
Compliance with RF Exposure Standards (If appropriate, Reference to the actual product’s Safety
Marking)
Your Retekess radio is designed and tested to comply with a number of national and International standards
and guidelines (listed below) for human exposure to radio frequency electro-magnetic energy.
FCC ID
The FCC ID means: This radio complies with the IEEE (FCC) and ICNIRP exposure limits for
occupational/controlled RF exposure environments at operating duty factors of up to 50% talk-50% listen and
is approved for occupational use only.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Warning:
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The CE marking means: Hereby, Henan Eshow Electronic Commerce Co.,Ltd. declares that the radio
equipment type TW101 is in compliance with the RED Directive 2014/53/EU and the ROHS Directive
2011/65/EU and the WEEE Directive 2012/19/EU
The full text of the EU declaration of conformity is available at the following internet address: www.tivdio.com
IC ID
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions:
(1)This device may not cause interference, and
(2)This device must accept any interference, including interference that may cause undesired operation of the
device.
Installation instructions
The host was placed on the table, with the staff.Outside speaker will be posted on the outside of the glass on
the table, used by the client .plug of outside speaker plugs into the wire hole of the host.
Adapter into a 100V - 240V power supply,DC plug into the host plug wire hole.
Check that the plugs and jacks all connected correctly, open the hosts on the power switch, power indicator
light.
From low to high, gradually adjust the volume adjustment button on the host, so that insideand outside the
volume level appropriate.
Install icon
Trouble shooting
Whistle
Installation environment noise performance is poor, or too much other noise, you should make the distance
larger between the host and the outside speaker or adjust the volume down.
Silent
100V - 240V power supply is not plugged in or loose, you should plus DC12V adapter into the host plug wire
hole. Volume is not adjusted, Re-adjust the volume adjustment button.
Staccato
The spokesman from the microphone too far away, it should be a little closer (less than the 20CM better).
When one party to speak, the other to grab, then will be mutually exclusive.
Ambient noise is too strong, the corresponding speaker volume down, or require the speaker close to the
microphone a little.
Performance Data
Working voltage: DC 12V/1A
Main sound(sub sound):3W
Inside microphone:-48db 20Hz-20KHz
Outside microphone:-48db 20Hz-16KHz
Exterior size: 18.2x13x5.6cm
6.1x8.5x2.4cm
Card line-bit
Glass windows
Windows
Power input: DC 12V/1A
Speaker / Mic: Connected outside speaker
REC OUT: Inside and outside the two-way
voice signal output
(recording by the bank teller)
ATTENTION!
Before using this radio, read this guide which contains
important operating instructions for safe usage and RF
energy awareness and control for compliance with
applicable standards and regulations.
DC12V
MIC/SPK REC OUT AUX IN
