Restomod Air FIREBIRD TRUMOD 1969, Install Manual

Page: 5 / 8

CONDENSER
• You can perform most of the following steps on a clean flat surface like a workbench. Lay the condenser down so that both hose connections are
on the left side (the larger connection will be on top).
• The drier is conveniently mounted on the left hand side of the condenser. First insert the drier into the drier mounting bracket (it’s basically a
sleeve for the drier).
• Attach the drier liquid tube to the drier and also to the connection on the condenser (tighten connections at either end using supplied o-rings on
both ends and a few drops of mineral oil to each o-ring).
• With these two components combined it will easy to find the correct place to attach the drier bracket to the condenser with the included #10-20
x 1/4” screws (attach drier and bracket from the front of the condenser).
• Screw the high-pressure switch into the port on the top of the drier. Go ahead and plug the pressure switch harness into the switch at this time
(black electrical boot with two long white wires).
• Install the upper condenser bracket using four #10 - 20 x 1/4“ screws in the top two holes on each side. Next, attach the lower brackets using the
bottom two holes, with the same size screws. These brackets have a bend that will face away from you.
• Remove the hood latch assembly. Retain original hardware. Slide condenser assembly down in front of the radiator.
• Locate condenser in the center of the radiator. Attach top condenser brackets to the bulkhead using (2) #10 Tek screws.
• Located behind the air dam and at the lower radiator bulkhead, attach the lower condenser brackets using (2) # 10 Tek screws.
• Reinstall hood latch assembly using original hardware.
• Attach Liquid tube to the drier using the #6 o-ring and a few drops of mineral oil.
• Attach Discharge tube to the condenser using #8 o-ring and a few drops of mineral oil.
• Attach the support bracket to the radiator bulkhead using (2) #10 x ¾” tek screws.
• Attach liquid and discharge tubes using the tube clamp, using (1) #10 x ½” screw.
CONDENSER BRACKETS
DISCHARGE TUBE
LIQUID TUBE
Two #10 - 16 x 3/4" Tek Screws
(upward from bottom)
Two #10 - 16x3/4"
Tek Screws
#10 - 20x1/4"
Screw
Fit brackets loosely into the
top two holes of the condenser, both sides
Fit brackets loosely into the bottom two
holes of the condenser, both sides
RESTOMODAIR.COM | P A G E 0 4