9
3.2 Powering up the system
Trouble Shooting
@ ][$
Press and Hold the power key for one second to power on the system. To Power off, press
and hold the power key for two seconds.
After system power on, adjust the camera viewing position again if necessary.
PROBLEM
SOLUTION
No camera picture
The power supply adaptor for the monitor
camera(s) is not plugged in.Camera out of range.
Locate camera closer to the receiver.
Poor picture quality
Clean the camera lens.
A white image
appears at night
The camera's infra-red LEDs shine invisible light
that reflects of surfaces such as glass causing
white light. Place the camera on the other side
of windows to try to improve the night vision or
place in a well lit area.
not record under
SCHEDULE/
MOTION detection
setting
Ensure correct DATE AND TIME has been set
and the Record Schedule setup correctly.
Ensure the memory card is inserted into DVR
and formatted.
RESET
AV OUT
DC 5V/1A
RESET
AV
OUT
DC 5V/1A
ON/OFF
power button
Remove the isolation tab from the
Remote Control to power it up