2-1
B
I
pap p
lus
m s
erIes
u
ser
m
anual
C
hapter
2: d
evICe
C
ontrols
and
d
Isplays
This chapter describes the device’s control buttons and displays, patient circuit connections, and
rear panel connections.
2.1 C
ontrols
and
d
Isplays
Figure 2–1 shows the three primary control buttons on the BiPAP Plus M Series device.
Bi-Flex
f
Igure
2–1 p
rImary
C
ontrol
B
uttons
These buttons are described below.
B
utton
d
esCrIptIon
Ramp – When the airflow is on, this button allows you to activate or restart
the ramp function. Ramp lowers the airflow pressure and then gradually
increases it, allowing you to fall asleep more easily.
Start/Stop – This button starts the device’s airflow and places the device in
the Active state, or stops the airflow, and places the device in Standby. You
can also press this button to exit any setting screen.
Bi-Flex
Bi-Flex – This button adjusts the Bi-Flex comfort setting.
If you do not want to modify the settings that your home care provider has set for you, you only
need these three buttons to start and stop therapy and do not need to use the display buttons located
under the device cover door.
Figure 2–2 shows the device display and navigation buttons that are under the cover door.
f
Igure
2–2 d
Isplay
B
uttons
The display buttons are described below.
B
utton
d
esCrIptIon
Allows you to access the Data screens. Also allows you to navigate to the
previous screen when in the Data or Setup menu.
Allows you to access the Data screens. Also allows you to navigate to the
next screen when in the Data or Setup menu.
Allows you to decrease the settings on the setup screens.
Allows you to increase the settings on the setup screens.
