Revision 2.1D
Page 13 of 14
www.resourcedm.com
Mercury Switch User Guide
Warning
Please Note
The specifications of the product detailed on this
Set-Up Guide may change without notice. RDM
Ltd. shall not be liable for errors or for incidental
or consequential damages, directly and indirectly,
in connection with the furnishing, performance or
misuse of this product or document.
Ensure that all power is
switched off before
installing or maintaining
this product
Network Alarms
The table below shows the text and associated type number that is sent to the system "front end". The type number is normally used to
provide different alarm actions.
Alarm text
Type # (Index)
Transducer Fault
6
High Pressure Alarm
8
MOP Alarm
3
Remote Pressure
6
Setup via Webpages
The Mercury Switch can be configured by navigating to the Mercury Switch WebPages. This can be achieved by using the Controller Info
page in the Data Manager/Data Director. Find the IP address assigned to the Mercury Switch in question from the list. Now connect a
laptop onto the IP network on which the Mercury Switch is connected. Using a web browser navigate to the IP address of the Mercury
Switch. The homepage of the Mercury Switch is shown below: -
Click on “Configure” to set the type: -
Then click “Type”
Use the drop-down selec
tion to select the type required and then click “Set Type”. Parameters can be changed using the connection as
illustrated above or through the normal Data Manager/Director change parameter routes or through the display if fitted (PR0445).
