RE202_Honeywell-Compat_Pencil_DWS_Instructions.doc Page 1 of 3
28-Jul-11
www.ResolutionProducts.com
Wireless
Security
Solutions
RE202 Honeywell-Compatible Pencil Door / Window
Features
•
Senses opening or separation. Narrow mounting locations.
•
½ width of competitive products. Great for casements!
•
Magnet and Internal reed switch operation.
•
Magnet can mount beside or over sensor housing.
•
Strong, reliable RF signal.
•
8-10 year battery life on 2-AAA batteries.
Key Instructions
•
Battery “+” faces towards white “+” on circuit board.
•
Install batteries: rear batt – tail in first, front battery – nose in first.
•
Board goes in and out of housing without batteries (not with).
•
Reed switch is at the top of the housing, near the push button hole.
•
Reed switch = Loop 2
•
(Inserting battery will send a Loop 4 Tamper, but Sensor does not
actually have a tamper)
•
Enrolling:
Place Panel in RF Learning mode.
Input Type = RF
Lynx *56 “E I” mode:
To enroll any particular loop: cause the loop to fault…
restore… (panel should beep to indicate ID capture)…
fault… restore… [panel will confirm enrollment].
Vista *56 “10 INPUT S/N: L” mode:
Transmit two open/close sequences (using magnet).
Press * (to check for duplicate serial/loop number).
Press * (to continue to confirmation screen).
Press * if you wish to skip confirmation; or “Yes” and
activate the loop to confirm.
RE202_Honeywell-Compat_Pencil_DWS_Instructions.doc Page 2 of 3
28-Jul-11
www.ResolutionProducts.com
Operation
•
Magnetic reed switch:
Alarm, when…
… magnet is pulled away from reed switch.
•
Supervisories, every hour.
Specifications
Magnet trip distance:
0.75 inch nominal
Mounting hardware:
# 4 or #6 screws
Replacement Battery:
2 AAA Alkaline
Temperature Range:
0F to 120F
Housing dimensions:
4 x 0.6 x 0.9 inches.
Specifications subject to change without notice.
Internal Picture
ID Barcode
Wall mount
plate
Battery
Positive
Magnet
position
Reed
Switch
