6
Note:
If the clip does not slide easily, check that the pillow sleeve edge is
fitted flush to the groove of the frame.
3
Attach the headgear ring to the pillow sleeve assembly. To do this, firmly
push the headgear rings onto the ends of the frame
(D-3)
. When attaching
the pillow sleeve assembly make sure:
•
the headgear panels are facing out
•
the nasal pillows are pointing upwards
•
the ResMed logo faces out—away from the headgear.
Make sure the pillow sleeve assembly is properly fitted to the headgear
before going on to the next step.
4
Attach the short tube assembly to your preferred side of the pillow sleeve
assembly. To do this, push the elbow into the seal ring until it clicks into
place
(D-4)
.
5
Insert the cap into the other seal ring until it clicks into place
(D-5)
.
6
The assembled system should look like this
(D-6)
. Make sure the ResMed
logo on the pillow sleeve faces out—away from the headgear.
Additional Information
Reassembling the Headgear
See section
E
on the illustrations sheet.
If taken apart, the headgear has four parts:
A: Left strap; B: Right strap; C: Back buckle; D: Top buckle.
1
Lay out the four parts of the headgear as shown in
(E-1)
. The panels must
face up.
Note:
Before threading the straps, make sure that the buckles are positioned
as shown in
(E-2)
and
(E-3)
.
2
Thread the back straps through the back buckle (part C) as shown in
(E-2a)
and
(E-2b)
.
3
Thread the top straps through the top buckle (part D) as shown in
(E-3a)
and
(E-3b)
.
Disposal
The Mirage Swift II Nasal Pillows System does not contain any hazardous
substances and may be disposed of with your normal household refuse.
60891r1.book Page 6 Monday, April 24, 2006 8:44 AM
