Residentia RH62GB, User Manual

Page: 8 / 16

\ 08
Through your wall
Further to your various ducting options, below are some tips on how to
correctly duct your rangehood:
– Always use correctly sized ducting – DO NOT reduce the size of the ducting
– Always use solid ducting
– Always use non-flammable ducting
– Always duct to the outside atmosphere
– Do not use flexible ducting
– Do not duct into the ceiling space- always vent to the outside atmosphere.
– Avoid sharp 90 degree bends as much as possible, use 45 degree bends
instead wherever possible
– Duct to the outside atmosphere using the shortest duct run possible
– Use cylindrical ducting whenever possible
Positioning the rangehood Installation heights
– Over gas and electric cookers, Residentia Group recommends our
rangehoods to be mounted at a height of between 600-800mm above the
cooking surface.
– Electric cooktops must have a minimum height of 600mm from the
underside of the rangehood to the cooktop face.
– Gas cooktops must have a minimum of 650mm from the burner to the
underside of the rangedhood.
– Over open flame grillers or barbecues, the Gas Regulations require the
filters of the rangehood to be at least 1200mm above the cooking surface.
Installing the rangehood
– Once you’ve determined your installation height , Drill 3 holes to install the
mounting bracket(hook) onto the wall ensuring that It’s secured in a level
position,and tighten the bracket with screw plug and screw(ST4mm X 30mm).
When Finished, life up the hood and hang onto the wall bracket hook. (See pic A )
– Attach the extensible 150mm tube to the canopy . Put the inside chimney
with the outside chimney together,ensure that the inner chimney piece can
move freely inside.Now attach the chimney to the hood .When finished,fix the
outside chimney to the canopy, mark the hole and drill 2 holes ,then tighten
the outside chimney bracket with screw plug and screw(ST4mm X 30mm) .
(See pic B )
Besides , if you need the safety screws fixed into the hood,please mark ,
drill and tighten the hood with screw plug and screw(ST4mm X 30mm),you
will need to remove the grease filters first.( See Pic C )
– Slide the inner chimney to adjust the inner chimney height. When the height
you required is reached, mark it and accommodate the inner chimney bracket
with screw plug and screw(ST4mm X 30mm).When finished, fix the inner
chimney with the screws(4mm X 8mm) to the inner chimney bracket . (See pic C )
\ Installation Instructions \
Screw plug
Wall bracket
Holes on wall
850-950
195
Exhaust pipe
Cooker hood
pic A
pic B
pic C
Safety screw
Screw
(4mm x 8mm)
Screw
(4mm x 8mm)
Screw
(ST4mm x 30mm)
Screw
(ST4mm x 30mm)
Screw
(ST4mm x 30mm)
(ST4mm x 30mm)
Warning: Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards.
The warning shall be in the same part of the instructions that include
details of how to mount the equipment.