6
There
should
be
a
space
character
between
independent
commands
e.g.:
1111<space>NEWP:1234<space>DEL1<space>DISABLE
Device is case sensitive; please pay attention to text message ingredients.
Attention: If you write the password wrong you will receive an SMS including “WRONG PSWR” text. In
that case device will keep in configuration mode. Please wait until LED becomes solid again and send a
configuration SMS with correct password. Otherwise device will keep the same settings and continue
operation after 2 minutes timeout and LED will become OFF.
Below is the list of commands:
DESCRIPTION
COMMAND
DEFAULT
Change Password
NEWP:XXXX
1111
Add / Change User1
TEL1:+XXXXXXXXXX
Add / Change User2
TEL2:+XXXXXXXXXX
Delete User1
DEL1
Delete User2
DEL2
Enable Keep Alive
ENABLE
Enabled (Weekly)
Disable Keep Alive
DISABLE
Enabled (Weekly)
Reset Device
RESET
Table – 1 “Commands List”
EXAMPLE:
1111 NEWP:5555 TEL1:+906661234567 TEL2:+907771234567 DISABLE
Above example means:
o
New admin password is now “5555” and you have to use this new password to make new
configurations in the future. Please note it carefully.
o
You added a new user1 906661234567.
o
You added a new user2 907771234567.
o
Weekly keep alive messages are disabled.
Once you sent this SMS to your device, it will reply you with an SMS including “CONFIG OK <XX>”
text (where XX is GSM signal strength, see “Table-2” for further details). Now LED will turn off and
your device is ready to operate.
Finally close the cover and insert screws on the back.
<XX>
MEANING
ADVICE
Between 19~31
Excellent Signal
Between 14~18
Good Signal
Between 9~13
Workable Signal
Try changing location
Between 1~8
Weak Signal
Check antenna / change device location
Table – 2 “GSM Signal Strength Levels”
