02
03
2.2 Installation and setting guide
Step1-Connect Ethernet and Power Cables
2.1 Hardware interface introduction
1.2 Three phase wiring diagram
a)Reset button: pressing this button will restart the system.
b)Ethernet port: connect to the router or your computer for monitoring
c)USB port: allow to connect a USB flash disk, keyboard, or mouse.
Step2- Power up,click the setting button
Power up the MRG, wait 1-2 minutes and the main interface will be showed,and then click the
rightmost setting button to enter the setting interface.
Figure 2.1 Hardware interface introduction
Figure 2.2.1 Connect Ethernet and Power Cables
Figure 1.2 Single phase wiring diagram
2. Installation
Three phase output must be installed a MRG on each phase, otherwise could not
detect the data of mirco inverters.
a)
b)
c)
a) Plug the Ethernet cable into the Ethernet port on the MRG.
b) Plug the other end of the cable into a port on the broadband router.
c) Plug the AC cord into a dedicated wall outlet.
MRG
AC power cord
Ethernet cable
Broadband router