REO REOTRON SMP CP 24-5, Instruction Manual

Page: 2 / 20

REOTRON SMP CP - CP/M
Instruction manual
2
Technical Information for the User
This description contains the necessary information for the correct application of the product described
below. It is intended for use by technically qualified personnel.
Qualified personnel are persons who, because of their training, experience and position as well as their
knowledge of appropriate standards, regulations, health and safety requirements and working conditions,
are authorised to be responsible for the safety of the equipment, at all times, whilst carrying out their nor-
mal duties and are therefore aware of, and can report, possible hazards (Definition of specialist according
to IEC 364).
Safety Instructions
The following instructions are provided for the personal safety of operators and also for the protection of
the described product and connected equipment.
Warning!
Hazardous Voltage
Failure to observe can kill, cause serious injury or damage

Isolate from mains before installation or dismantling work, as well as for fuse changes or post
installation modifications.

Observe the prescribed accident prevention and safety rules for the specific application.

Before putting into operation check if the rated voltage for the unit conforms with the local
supply voltage.

Emergency stop devices must be provided for all applications. Operation of the emergency
stop must inhibit any further uncontrolled operation.

Electrical connections must be covered

Earth bonding must be tested prior to operation
Prescribed Use
The units described herein are electrically powered for use in industrial applications and are not suitable
for domestic use
Declaration of conformity
We declare that these products conform with the following standards and directives:
Directives: Standards:
- 2014/30/EU EMC - EN 61000-6-4:2007 +A1:2011; EN 61000-6-2:2005
- 2014/35/EU LVD - EN 50178:1997
- 2011/65/EU RoHs
REO AG, D - 42657 Solingen
!
RoHS
COMPLAINT