AB500HS
Calendar hanger tool (KAS)/optional
page
15.5 Connect the KAS at the AB 500HS
•
Put the KAS onto the tool holding rail
c
of the AB500HS. Pull the KAS in direction
i
as shown
beside. The two „noses“
e
should fit at the tool holding rail.
•
Do not tighten the screws of the clamping angles
d
because the side position of the KAS must be
adjusted later on.
•
Plug in the pneumatic pipes into the cylinder connectors
f
+
g
. The connectors of the cylinders and
the pipes are marked with a colored tape.
•
Plug in the plug
h
for the recount function for missing shafts.
Caution
•
Plug in the plug for the recount function always directly after you put the KAS
unit onto the tool holding rail.
•
The plug must be connected before you activate the KAS function in the
display. This avoids wrong recognition of missing shafts.
Danger
Be careful when you put the KAS unit onto the AB500HS. The KAS unit has a
weight of about 30-35kg. Please do this work always with two people.