19
en
Fixscreen
®
100
EVO
Solar
If the box is completely fixed (on the structure), you need to
mount the fabric roller. You need to do this with two persons!
Support the bottom bar while doing this. Put the shield plate
back in the cabinet with the 2 Torx screws using tool T20.
Make sure the shield plate avoids contact between the cable
and the fabric roller. Then, slide the front cover on the box.
Warning!
Slide the fabric roller left and right into the slides
simultaneously.
5
Slide the fabric into the internal HPVC channel.
Check if the side channels are facing the right direction!
The V cut-out is positioned at the top of the side channel and the
clicker is positioned at the bottom of the side channel.
Connect the cable from the motor to the connector in the front
cover. Make sure the hook is attached correctly. Close the
bottom of the box with the 2 screws at the side supporting end
pieces with a Torx key (DIN 7985 TX – M4x40 – A2).
Remove the protection film on the solar cell.
7
6
Screw the front part to the back part side channel to complete.
8
