28
Operating Instructions
English
Recording
• Recording onto cassettes is only possible on deck B.
• Press the key POWER (1) to switch on the device.
• Press the
/
STOP/EJ
button from deck B.
• Put an unrecorded Cassette with tape opening downwards in deck B.
• Close the drive.
• If it is a CrO
2
-Cassette, press the button REC CrO
2
(8). When the button is activated a red control LED flashes
on the display (4) above the button.
• Put the switch NOISE REDUCTION (3) into the desired position:
The cassette should be recorded with the hissing reject system > put switch to ON.
The cassette should be recorded without the hissing reject system > put switch to OFF.
Recording from an external audio source
• Choose the desred audio source on your amplifier, whose signal should be recorded.
• Press button
PAUSE
at deck B.
• Press the buttons
REC
and
PLAY
from deck B at the same time.
• Start replay at your recording source and press button
PAUSE
at deck B again to start the recording.
• During the recording the display (4) flashes a red control LED on the right upper side.
• Control the recording with the control REC LEVEL (6) by setting the control in a way, that the red section of the
control display on the display (4) only flashes very shortly when signal is very high.
• Press the button
PAUSE
to interrupt the recording shortly. To continue recording press button
PAUSE
again.
• Press the button
/
STOP/EJ
, to end the recording.
• Press the button
/
STOP/EJ
again, to remove the cassette.
The recording ends automatically when the tape ends.
