29
•
For this, use the mounting bracket to install the two screws at the bottom plate and attach the effect light to the
traverse system with the traverse clamp. Use only assembly material suitable for the type of assembly and for
bearing the effect light load.
•
The assembly must never swing freely.
•
Additionally secure the installation with a suitable safety restraint cable or a safety net. The corresponding ring
screw that you can screw into the free thread of the bottom plate in addition to the mounting bracket is enclosed
with the device.
•
The safety retention rope or the net must be designed to support the effect light in the event of failure of the main
support system independently of the main attachment.
•
Make sure that the projector head of the effect light can move freely; it may not hit onto anything or be blocked.
9. DMX Connection
You can operate a maximum of 32 devices in a DMX chain without overloading the controller.
The maximum total length of the DMX chain should not exceed 500 m.
Use of XLR microphone cables may cause interferences in the DMX signal transmission. In this case,
please use special DMX high-frequency cables.
a) Connection of a DMX Controller
Only connect the device to a DMX controller with a DMX-512 protocol.
•
Connect the port DMX IN (6) with the output of the DMX controller.
•
The controller must have up to 11 or 39 free control channels depending on the operating mode.
•
Connect DMX OUT (7) with the DMX input of the subsequent DMX device.
•
Proceed accordingly with all other devices of the DMX chain.
•
If the effect light is the last or the only device in the DMX chain, insert an XLR plug with a 120 ohm/0.25 W
terminating resistor into the DMX OUT (7) socket (between Pin2 and Pin3).
