This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represent the technical status at the time of printing.
© Copyright 2016 by Conrad Electronic SE.
1487097_V1_0916_02_VTP_m_en
PC or MAC:
• You can also operate the converter board with a PC or MAC.
• In principle, installation and operation with a PC or MAC is the same as with the Raspberry Pi
®
.
Please note! The converter board is not designed for installation in a PC or MAC. If
you nevertheless plan to do so, please observe the special safety instructions of this
manual.
Since the screw set is only intended for attachment to a Raspberry Pi
®
, make espe-
cially sure that the converter does not cause a short circuit in this case (e.g., through
contact with the PC housing).
When using the 5-pin connector (USB_P or U20_P1), also observe the operating instructions
of your computer or main board for the correct allocation.
Disposal
Electronic devices are recyclable material and do not belong in the household waste.
Please dispose of the product, when it is no longer of use, according to the current
statutory requirements.
You thus fulfil the legal requirements and make your contribution to protecting the
environment.
Technical Data
Voltage supply ................................... via micro USB2.0 (USB_M or U20_M1) or 5-pin con-
nector (USB_P or U20_P1); alternatively via micro USB
connector (PWR_U or DC5V_IN)
Operating voltage .............................. 5 V/DC
Supported operating systems ............ Windows
®
XP SP1 or higher (only 32 bit); Windows
Vista
TM
, Windows
®
7, Windows
®
8, Windows
®
8.1,
Windows
®
10 (32 and 64 bit); MacOS; Linux
Connectors ........................................ M.2 NGFF 2280-D5-B port (B key); micro USB2.0
connector; 5-pin USB connector; micro USB connector
for separate voltage supply
Supported standards ......................... USB 2.0; SATA
Supported devices ............................. M.2 NGFF SATA SSD; type: 2280, 2260, 2242, 2230;
double sided module, max. height 1.5 mm
Dimensions (L x W x H) ..................... 89 x 57 x 12 mm
Weight ............................................... approx. 20 g (only the board)
Operating conditions .......................... 5 °C to +50 °C; 20% to 80% rF, non-condensing
Storage conditions ............................. -25 °C to +70 °C / 15% to 90% rF non-condensing