Step 12.
LOCK ASSEMBLY LPA-13
A. Inspect for damage and wear, particularly in the area where the
lock handle engages the auxiliary lock’s locking button.
B. Inspect lock handle for binding, particularly when moving lock han-
dle to the “Lock Closed” position. If binding does occur, adjust set
screw in body of lock handle to provide adequate clearance. Refer
to Illustration M, Step 11.
C. Inspect lock assembly pivot shaft for wear. Shaft must have “Slip
Fit” with lock handle pivot hole. Refer to exploded view.
WARNING: Replace lock assemblies that have worn or damaged
parts, fit loosely in the body mounting hole and do not have a def-
inite “Over Center” “Lock Closed” position. Replace worn and
damaged bearings if supplied on clamp.
Step 13.
ASSEMBLY
After reassembly, check operation of clamp. All parts should move
freely without binding. Refer to exploded view for proper location of
component parts.
WARNING: All retaining pins and fasteners must be in place, in-
cluding cam jaw washers where required.
GENERAL
RENFROE products may be returned to the factory for inspection and
refurbishment in accordance with an established fee schedule.
Use only RENFROE replacement parts. Refer to RENFROE catalog
for instructions on ordering replacement parts.
WARNING: Do not weld, grind or modify the clamp body or com-
ponent parts in any manner. In the event the stenciling is worn
and not legible or the tag containing the model, capacity, or other
pertinent information is missing—do not use clamp until it has
been properly labeled. Renfroe will replace tag at no charge upon
request.
Summary of Contents for LPA
Page 4: ......
