Renfert Silent TS 2921-0050, Instruction Manual

Page: 15 / 18

- 9 -
Error Possible cause Corrective action
%
up when the unit is
switched on. N !!\ N [;XK
&
open. N =] N O] &?
required.
Information for Operators
The following information is intended to assist you,
the operator, in safely working with the
Silent TS in
your laboratory.
Using these operating instructions as a
starting point, instruct all operators of the
unit with regard to the area of application,
the possible hazards during operation, and
the proper operation of the dust extractor.
Please have these operating instructions readily
available for the operators.
A. Application Area
The Silent TS \ ] -
tract dusts such as occur in laboratories, e.g., dental
labs.
It is solely intended for commercial use in laboratories
and not for private, household use.
The
Silent TS can be operated both manually as well
\? ?x& -
ating equipment.
It is possible to connect one or two suction points
+
connected with a Y-adapter which is available as an
[ " %K
In order to protect the health of persons
working in a dental laboratory, the law re-
quires that specialised dust extractors must
be used.
National regulations state the MAK value
- maximum concentration of suspended
particles in the air.
Find out about the legal national threshold
value and the type of dust generated in
your laboratory.
A.1 Proper Use
_ ?x-
sive dusts.
) x &?Z?Z? -
! \
Silent TS .
+ ? &? &
materials is prohibited.
"%+
shall not be liable for any damages resulting from any
such other use.
+"%\
operating, servicing and preventive maintenance
$
A.2 Ambient Conditions
(in accordance with DIN EN 61010-1)
The unit may only be operated:
N †
N ?UUU!!†
N &\
Yx|UO‘|xU|)’“K†
N !ˆU”(O
‘ˆˆ)’? & YU” -
!|UO‘U|)’“K†
N j\ \ !&Z
U”!†
N  !†
N  ! x!&& †
“K}\Y•(UŒO‘|•ˆXŒ)’?
!ˆU” \
(•|UŒO‘ˆˆ•U|Œ)’?
proportionally in order to ensure operational readiness (e.g., at
(YŒO‘‰YŒ)’–XY”†|UŒO‘U|Œ)’–YU”K
The unit may not be operated at temperatures above 40°C
‘U|Œ)’
B. Hazard and Warning
Information
Only intended for indoor use. The unit is
only designed for dry applications and may
not be operated or stored outdoors or
under wet conditions.
The Silent TS laboratory dust extractor is an
electric device and, as such, carries with it
a certain inherent potential hazard. The unit
may not be taken into service until any re-
quired alterations to comply with regionally
been made. Such alterations may only be
'
The unit may only be operated if the infor-
mation on the nameplate conforms with the
supply.