R0E55630EDMB00
User's Manual
R20UT0583EJ0200 Rev.2.00
Page 5 of 8
Mar 05, 2014
6. Dimensions of the Debugging MCU Board
Figures 4 shows the dimensions and reference pad pattern of the debugging MCU board (R0E55630EDMB00).
1
44
133
45
88
89
132
Unit[mm]
19.00
23.00
19.00
23.00
0.50
0.25
0.50x35=17.50
R0E55630EVKZ00 REV.A
TP6
50.00
50.00
X1
POWER
TP7
GND
CN3
1
37
2
38
TP5
TP4
TP3
TP2
TP1
VCC
VBATT
AVCC0
VREFH
VREFH0
VCC_USB
IC1
18.30
10.50
10.50
25.00
25.00
10.50
10.50
176
Figure 4 Reference Foot Pattern and Dimensions of This Product (R0E55630EDMB00)
7. Notes on Usage
READ the following warnings before using the debugging MCU board. Incorrect operation will damage the debugging
MCU board and user system. The USER PROGRAM will be LOST.
Notes on Connecting the Debugging MCU Board:
•
Cables must not be connected or removed while the power is on.
•
Before connecting the debugging MCU board and user system, check that the pin 1 locations on both
sides are correctly aligned with each other.
Note on Rewriting the Flash Memory:
•
The number of times that the flash memory in the MCU installed on the debugging MCU board can be
programmed is limited. If an error in erasure occurs during debugging, replace the debugging MCU
board.
Notes on Debugging:
•
The debugging MCU board is only usable for debugging when it is connected to the user system.
•
Debugging by the debugging MCU board alone is not supported.
Note on Starting the Debugger and Selecting the MCU Type:
•
Select the MCU type for use in the device name section of the [Initial Settings] dialog box on initiation of
the debugger.
•
When using the High-performance Embedded Workshop:
When debugging an MCU with internal ROM size of 1 MB or 768 KB, select R5F5630E in the device
name section of the [Initial Settings] dialog box on initiation of the debugger.
•
When using the e
2
studio:
When debugging an MCU with internal ROM size of 1 MB or 768 KB, select R5F5630E for the target
device.
