Renesas QB-RL78D1A2, User Manual

Page: 11 / 41

QB-RL78D1A2 In-Circuit Emulator CHAPTER 1 GENERAL
R20UT3110EJ0101 Rev.1.01 Page 11 of 41
Nov 28, 2014
1.3 System Specifications
This section shows the QB-RL78D1A2 system specifications.
Table 1-2. QB-RL78D1A2 System Specifications
Parameter Specification
Emulation memory capacity Internal ROM 512 KB (MAX.)
Internal RAM 61.75 KB (MAX.)
Program execution
functions Real-time execution function Go, Start from Here, Come Here, Restart, Return Out,
Ignore break points and Go
Non-real-time execution function Step In, Next Over, Slow motion, Go & Go
Memory manipulation Available (initialize, copy, compare)
Register manipulation Available (general-purpose registers, control registers, SFRs)
Disassemble function Available
Local variable view Local variables
Watch data view Local variables, global variables, or else
Stack trace view Available
Break functions Event break Execution: 8 points
Access: 8 points
Software break 2000 points
Pre-execution break 4 points
Fail-safe break Non-map, write protect, SFR illegal access, stack overflow, or else
Other Forcible break, trace full break, trace delay break, timeout break,
timer overflow break
Trace functions Trace data types Program address, program data, access address, access data,
status, time tag
Trace modes Unconditional trace, section trace, qualify trace, delay trigger trace
Trace functions Non-stop, full stop, full break, delay trigger stop, delay trigger
break
Memory capacity 128K frames
Real-time RAM monitoring function All internal RAM spaces
Time measurement
functions Measurement clock 120 MHz
Measurement objects
Start through end of program execution
Start event through end event
Maximum measurement time Approx. 40 hours and 43 minutes
Minimum resolution 8ns
Number of timers for
measurement Start through end of program execution: 1
Start event through end event: 2
Measurement results Execution time (start through end of execution)
Maximum, minimum, average, total, pass count (between events)
Other Timer overflow break function, timeout break function
Other functions Command functions set in the console, mapping function, event
function, coverage function, snapshot function, DMM function,
power-off emulation function, pin mask function, flash self-
programming emulation function