Renesas QB-78F1026, User Manual

Page: 31 / 39

QB-78F1026 CHAPTER 2 SETUP PROCEDURE
R20UT0290JJ0100 Rev. 1.00 Page 25 of 29
Sep 30, 2010
2. 8 Connecting USB Interface Cable and AC Adapter
Plug the USB interface cable supplied with the QB-78F1026 into the USB connector of the host machine, and plug the
other side into the USB connector on the rear of the QB-78F1026.
Plug the AC adapter supplied with the QB-78F1026 into a receptacle and plug the other side into the power supply
connector on the rear of the QB-78F1026.
For QB-78F1026 connector positions, see Figure 2-9 .
Figure 2-9. Connector Positions
2. 9 Switching Power On and Off
Be sure to switch the power on and off according to the following procedures.
- Switching power on - Switching power off
<1> QB-78F1026 power on <1> Debugger termination
<2> Target system power on
Note
<2> Target system power off
Note
<3> Debugger startup <3> QB-78F1026 power off
Note In the procedures, <2> is unnecessary if the target system is not connected.
Caution If the wrong sequence was used for the operation, the target system or QB-78F1026 may fail.
Power supply connector
(Connect AC adapter)
USB connector
(Connect USB interface cable)