PC7501 User’s Manual
2. PC7501 System Configuration
R20UT0207EJ0500 Rev.5.00
Page 18 of 50
Nov 01, 2010
2.4 Specifications
Table 2.1 lists the specifications of the emulator PC7501.
Table 2.1 Specifications
Supported MCUs
M16C Family and R8C Family (32/16-bit or 16-bit)
Max. operating clock frequency
66.7 MHz *
P
1
P
Emulation memory
The default is 4 MB *
P
2
P
Software break
64 points
Hardware break
16 points *
P
3
P
(Execution address/Bus detection/Interrupt/External trigger signal)
Hardware break condition
- AND/OR/AND (same time)/State transition
- Pass count: 255 times
Exception event detection
Access protect
Real-time trace
- 256K cycles
- Trace data: Bus, external trigger, and time stamp
- Five trace modes: Break/Before/About/After/Full
- Can be recorded ON/OFF by events
Real-time RAM monitor
- 4,096 bytes (256 bytes x 16 blocks)
- Data/Last access result
Execution time measurement
- Execution time between program start to stop.
- Maximum/minimum/average execution time and pass count of specified four
zones.
- Count clock: Equal to MCU Clock or 16 MHz
C0 coverage
8,192 KB (256 KB x 32 blocks)
External trigger input/event output External trigger input (MCU-dependent-voltage CMOS level x8) or event output
(break x1, event x7)
Host machine interface
- LPT parallel (ECP, EPP, Byte/compatibility and Nibble/compatibility modes)
- USB (USB 1.1, full-speed)
- LAN (10BASE-T)
Connection to the target system
By way of an emulation probe (optional)
(For details, see emulation probe data sheets.)
AC supply voltage for emulator
unit
Supplied from an included AC adapter (100 - 240 V, 50/60 Hz)
Power consumption
48 W maximum
External dimensions *
P
4
P
Width: 433 mm, Depth: 140 mm, Height: 58 mm
Weight 740
g
Operating environmental
conditions
- Temperature: 5° to 35°C
- Humidity: 20% to 80% (non-condensing)
- Dust and dirt: General office environment
Storage environmental conditions - Temperature: -10° to 60°C
- Humidity: 0% to 90% (non-condensing)
- Dust and dirt: General office environment
*1 Target-MCU-dependent. (For details, see an emulation probe user's manual.)
*2 Available memory and the required wait states depend on the target MCU. (For details, see an emulation probe user's
manual.)
*3 The number of user-settable hardware break points depends on the specifications of the emulator debugger
M3T-PDxxF.
*4 For details of the external dimensions, refer to "7.1 External Dimensions of the Emulator PC7501" (P.45).
