M30870T2-CPE User’s Manual
4. Hardware Specifications
REJ10J0766-0400 Rev.4.00 February 16, 2006
IMPORTANT
Notes on A/D Conversion:
When selecting the MCU file "m30870_ad.mcu" in the Init dialog box of the emulator debugger to execute the
A/D conversion debug, note the following.
When setting the register below to use the analog input port selection function, you need to set the direction
register of port P15 for a pin that performs A/D conversion to “input”.
And you need to set the function selection register of port P15 for a pin that performs A/D conversion to “I/O
port”.
A/D0 control register 2 (address 394h)
b2, b1
1,
0
: AN00 to AN07
1,
1
: AN20 to AN27
Also, when the P0 group and P2 group are selected for A/D input, port P15 cannot be used as an I/O port, When
setting the register above, port P15 cannot be used as an I/O port even if A/D conversion is halting.
For the switch SW5, refer to “2.9.1 Setting Switches of Emulator” (page 39).
When setting the register below to use multi-port sweep mode, you need to set the direction register of port P15
for a pin that performs A/D conversion to “input”.
And you need to set the function selection register of port P15 for a pin that performs A/D conversion to "I/O
port".
A/D0 control register 4 (address 392h)
b3, b2
1,
0
: AN0 to AN7, AN00 to AN07
1,
1
: AN0 to AN7, AN20 to AN27
Also, when the P0 group and P2 group are used for multi-port sweep mode, port P15 cannot be use as an I/O
port. When setting the register above, port P15 cannot be used as an I/O port even if A/D conversion is halting.
Because a converter board and other devices are used between the evaluation MCU and the user system, the
A/D converter operates differently from an actual MCU. Make the final evaluation of the A/D converter using
an actual MCU.
Page 92 of 102
Summary of Contents for M30870T2-CPE
Page 102: ...M30870T2 CPE User s Manual ...
